Industrial 1-port RS422/485 Modbus Gateway – IMG-110T

The IMG-110T, industrial level 1-port RS422/485 Modbus Gateway, is a bridge that converts between Modbus TCP/IP Protocol and Modbus RTU/ASCII Protocol.

Specifications
Interface: RS422/ RS485 x 1

Connector: 5-contact terminal block for RS422/RS485

Isolation: Serial port isolation

Baud Rate (Data Rate): 300bps to 115200bps

Data Bits: 7, 8

Parity Type: Odd, Even, None, Space, Mark

Stop Bit: 1, 2

Flow Control: H/W, None

Signals:
RS422 : Tx+, Tx-, GND, Rx+, Rx-
RS485: Data A (+), GND, Data B (-)

Distance: RS422/RS485 for 1200m transfer distance

Operation Mode:
RTU Master/RTU Slave/ASCII Master/ASCII Slave
Master mode: Supports up to 32 slave TCP connection requests
Slave mode: Supports up to 16 TCP master connection requests

Standard:
IEEE 802.310BASE-T standard
IEEE 802.3u 100BASE-TX standard
IEEE 802.3x Full-duplex flow control

Connector: RJ45

Distance: 100 meters

Copper Port: 10/100BASE-T RJ45 TP x1, auto-MDI/MDI-X, auto-negotiation

Serial Port: RS422/RS485 x 1

DIP Switch: Reset system to factory default

LED Indicators:
System: Power x 1
10/100BASE-TX Port: Link/Active x 1
RS422/RS485 Serial Port: TX (Transmit) x 1, RX (Receive) x 1

Operation Mode:
RTU Master
RTU Slave
ASCII Master
ASCII Slave

Dimension (W x D x H): 69 x 100 x 22 mm

Weight: 238g

Power Input Connector: 2-contact terminal block connector DC power (9-48V) *

Power Consumption: 1.61 watts/5.4BTU (max.)

Installation: Wall-mount kit

Mechanical: Metal

Temperature:
Operating: -40~75 degrees C
Storage: -40~75 degrees C

Humidity:
Operating: 5~95% (non-condensing)
Storage: 5~95% (non-condensing)

*Remarks: Please follow the DC power input symbol from the front panel of the IMG-110T
— insert positive DC power wire into V+, and negative DC power wire into V-. Otherwise, it will damage the device.