SGFEB Series

The SGFEB Series is a stand-alone media converter that provides an interface between 10/100/1000Base-T ports and 1000Base-SX/LX ports, allowing users to integrate fiber optic cabling into 10/100/1000 copper environments. Operating at Layer 2, the data link layer, this converter not only converts copper to fiber, it also provides rate conversion allowing legacy 10/100 copper devices to connect to 1000Base-SX/LX fiber.

Specifications
Data Rate:
Copper: 10/100/1000 Mbps
Fiber: 1000 Mbps, 100 Mbps also supported via SFP port

Filtering Addresses: 8K MAC addresses

Max Frame Size: 10,260 byte Jumbo Frames

Dip Switch:
Two Port Models
Switch 1: TP1 – Auto-Negotiation Enable / Disable
Switch 2: TP1 – Force 100Mbps or 10Mbps with switch 1 disabled
Switch 3: TP1 – Force Full or Half-Duplex with switch 1 disabled
Switch 4: Link Pass Through Enable / Disable
Switch 5 & 6: Controls the Fiber SFP port for 1000M, 100M, or SGMII Multiport Models with additional 4 position dip-switch
Switch 1 & 2: Controls the 2nd Fiber SFP port for 1000M, 100M, or SGMII
Switch 3 & 4: Fiber Redundancy Enable/Disable, Revertive Mode, and Fiber P2/P3 blocking

Status LEDs:
PWR (Power): On = Power is provided to converter
LACT (Fiber Link/Activity): On = Link, Blink = Activity
RJ-45 Upper Left (TPLink/Activity/Duplex): Green = Link Full-Duplex, Blink = Activity, Amber = Link Half-Duplex, Blink = Activity
RJ-45 Upper Right (Speed): Green = 1000Mbps, Amber = 100Mbps, Off = 10Mbps

Dimensions:
Width: 3.25” [82 mm]
Depth: 4.8” [122 mm]
Height: 1″ [25 mm]

Power Consumption: 2.2 Watts

Power Input: 7.5 to 24 VDC, Provided by wide input AC Wall Mount Adapter

Environment:
Operating: 0°C to 50°C
Storage: -15°C to 65° C
Humidity: 5% to 95% (non-condensing)
Altitude: 0 – 10,000 ft.

Weight: 2 lbs. [0.90 kg]

MTBF:
Greater than 250,000 MIL-HDBK-217F Hours.
Greater than 687,500 Bellcore Hours
When bundled with a typical 50,000 hour power supply:
Greater than 41,660 MIL-HDBK-217F Hours
Greater than 114,580 Bellcore Hours